01
Portability First
Aluminum construction — every product in the line is light enough to deploy with a small crew. The smallest davit weighs 38 lb; the largest 22,000 lb gantry assembles with forklift-assisted setup, no truck crane required.
Industries We Serve
Built for the Lifts
That Don't Fit a Fixed Crane.
Industries
4 core sectors
Capacities
1,100 – 22,000 lb
Standards
ASME · OSHA · CSA
Coverage
Every state & province
Every industry eme serves has the same underlying need: a rated lift point where there isn't one. Industrial maintenance crews need to pull a pump in a confined space. Mechanical contractors need to set rooftop HVAC. Riggers need to relocate machinery through a doorway. Aviation crews need to swap a helicopter engine without a hangar crane. The eme product line — portable aluminum gantries, davit cranes, Eagle Beam lifting beams — was built for exactly those four buyer profiles.
Engineered, Welded, and Tested for North American Jobsites
Engineered to
- ASME B30.17 Cranes and Monorails
- CSA B167 Overhead Travelling Cranes
- Aluminum Design Manual (ADM) US aluminum structural design
- CSA S157 Strength Design in Aluminum
Welded under
CSA W47.2
Canadian Welding Bureau aluminum welding certification
Workplace compliance
OSHA 1910.179
Supports employer compliance with applicable OSHA 1910.179 workplace requirements when installed, inspected, and used according to the operating manual.
Four Sectors. One Equipment Line.
Industrial Maintenance
Pumps, motors, switchgear, plant maintenance, wastewater pump pulls, and routine facility lifting where a fixed crane isn't available.
See solutions →
Construction & Mechanical Contracting
HVAC installs, rooftop placements, mechanical rooms, pharma build-outs, data-center construction — anywhere a portable, rated lift point matters.
See solutions →
Rigging & Equipment Moving
Machinery moves, plant relocations, tight-space positioning, low-headroom lifts where portable aluminum equipment outperforms a truck-mounted crane.
See solutions →
Aviation & Transportation
Helicopter engine and transmission lifts, fleet shops, terminal maintenance, on-trailer rigging — the lifts a portable aluminum gantry was made for.
See solutions →The Common Thread
Same Problem. Same Solution.
Every industry on the list above has crews working in spaces a permanent overhead crane can't reach. The lift might be in a confined mechanical room, on a rooftop, between two parked aircraft, or inside a vehicle bay. eme equipment shows up, sets up, lifts the load, and rolls back out — reducing the need for outside lifting support, extended mobilization windows, or fixed crane infrastructure.
02
Fast, Repeatable Setup
Same setup logic across every capacity tier — train crews once, deploy across the fleet. Gantries roll while loaded; davits drop into pre-installed sockets in seconds.
03
Engineered, Welded & Tested
Engineered to applicable ASME and CSA requirements. Welded under CSA W47.2 certification by qualified aluminum welders where applicable. Load-tested to 125% of rated capacity with a Certificate of Test.
04
Fleet-Friendly
Shared trolley families across the gantry line, shared socket family across the davit line, shared accessory inventory. Buy capacity without learning a new system.
Standards & Engineering
The Applicable Standards Framework for Each Product.
Standards vary by product and application. eme equipment is engineered to applicable ASME and CSA requirements, welded under CSA W47.2 certification by qualified aluminum welders where applicable, and load-tested to the rated configuration before shipment. The Canadian Welding Bureau audits the CSA W47.2 program as a third-party credential — not a manufacturer self-claim.
Browse the standards reference set for the technical details behind each spec.
See Standards Reference→Tell us what you're lifting.
A 5-minute conversation usually narrows the product list to one or two configurations. Send us your load, lift height, span, and jobsite — we'll quote the right combination.